The Sinar™ Combine Moisture Meter enables
the combine driver to monitor the moisture content of
the grain as it is being harvested and eliminates the
need to stop to sample and test the crop.
Easily mounted in the grain tank and with results transmitted
direct to the cab, the advanced design of the Sinar™
Combine Moisture Meter offers many advantages for time
and cost saving. In the first instance, it allows the
operator to determine when conditions are not suitable
for combining. |
 |
6330 also makes it easier to determine the best place to store
the grain after combining; the driver will have an accurate
moisture reading enabling him to decide whether or not the grain
needs drying. Furthermore it can be used in conjunction with
a grain yield monitor.
The moisture sensor is housed in a flow regulator of 100mm diameter.
The flow regulator is capped to isolate it from the effects
of changes in packing density in the tank. Apertures are located
on the sides and at the top of the regulator to allow the grain
to enter. The Grain exits through the bottom of the regulator
providing a single reading for each pass through.
To obtain an early measurement the optimum positioning of the
sensor is as low down in the tank as possible and close to the
region of the initial grain spill from the bubble auger. The
value for the moisture content of the grain should be measured
when the regulator is full. The regulator will clear as the
grain tank is emptied and be ready to measure freshly harvested
grain as it is augered in.
6330-001
|
Combine Moisture Meter |
| 6330-000 |
Combine Moisture Meter complete with sensor flow regulator,
digital cab display installation instructions, 3m cable
protection, 7m of signal cable and connectors,12 volt
supply |
| 1900-6616 |
Optional extra-magnet mounting kit for simple retrofit
installation |
Standard Calibrations : Wheat, barley, oats, oilseed rape,
peas and beans
Optional calibrations: Maize (corn), soybean, linseed and
sunflower
Accuracy: ± 0.5% mc (depending on application)
|
